This page is maintained for older versions of Spira only. The latest documentation can be found at: https://spiradoc.inflectra.com

Spira 4.2 User Manual Help Viewer

1. Introduction
2. Functionality Overview
3. User/Project Management
4. Requirements Management
5. Test Case Management
6. Incident Tracking
7. Release Management
8. Task Tracking
9. Resource Tracking
10. Document Management
11. Reports Center
12. Source Code
13. Planning Board
14. Mobile Access
Search:
1. Introduction
2. Functionality Overview
3. User/Project Management
4. Requirements Management
5. Test Case Management
6. Incident Tracking
7. Release Management
8. Task Tracking
9. Resource Tracking
10. Document Management
11. Reports Center
12. Source Code
13. Planning Board
14. Mobile Access

5.1.14. Viewing the Test Status for a Release

By default, when you view the list of test case cases, it will display an aggregate status for all releases of the project. I.e. the test list will include all the test cases in the system (regardless of which release they apply to) and the execution status will reflect the most recent test run – regardless of which release it was for.

To change the test case list to just display test cases and execution status for a particular release, simply change the release selected in the drop-down list located below the toolbar (on the right-hand side) from “Any” to a specific release:

As illustrated in the example above, when the drop-down list is changed to select a specific release, the list of test cases is filtered to just those mapped to the release in question. In addition, the execution status for the test releases will only reflect test runs for that specific release (and any child iterations if applicable). As can be seen in our example, many test cases that have been run for other releases now show the “Not Run” status since they’ve not been run for this specific release.

As a shortcut, when you select a specific release for viewing, subsequent execution of any of the test cases via the Tools > Execute menu option will default the test run to the selected release.