This page is maintained for older versions of Spira only. The latest documentation can be found at: https://spiradoc.inflectra.com

Spira 4.2 User Manual Help Viewer

1. Introduction
2. Functionality Overview
3. User/Project Management
4. Requirements Management
5. Test Case Management
6. Incident Tracking
7. Release Management
8. Task Tracking
9. Resource Tracking
10. Document Management
11. Reports Center
12. Source Code
13. Planning Board
14. Mobile Access
Search:
1. Introduction
2. Functionality Overview
3. User/Project Management
4. Requirements Management
5. Test Case Management
6. Incident Tracking
7. Release Management
8. Task Tracking
9. Resource Tracking
10. Document Management
11. Reports Center
12. Source Code
13. Planning Board
14. Mobile Access

5.2.2.2. Insert Link

Clicking on the <Insert Link> button brings up the following dialog box that allows you to choose the test case to be inserted:

You need to then select the name of the test case you want to insert as a link. If the test case has declared parameters (see the section on Parameters below for more details) you will be given a list of parameters that needed to be filled out.

You need to fill out the values of the parameters for the linked test case and then click the <Add> button to complete the operation. The system will then insert the test case as a link just before the currently selected test step. If no existing test step was selected, the link will be added at the end of the test step list.