Inflectra Customer Forums: Bulk Update Test Case Status to NA (Thread) Marking a Test case status as Obsolete reverts the test case status to N/A. However, when you check the test set and the Steps - they same to be No Run status. Is it incorrect to expect that even the steps will reflect as N/A? Or - Is it logically correct that since the Test case was not executed from the wizard that the steps remain in No Run. en-US(C) Copyright 2006-2024 Inflectra Corporation.support@inflectra.com/Computers/Software/Project_Management//Computers/Software/Quality_Assurance/KronoDesksupport@inflectra.comhttp://www.inflectra.com/kronodesk/forums/threads120/Support/Forum/spiraplan/issues-questions/2475.aspxthreadId=2475Prince Toms (ptoms@hpe.com)Bulk Update Test Case Status to NA Marking a Test case status as Obsolete reverts the test case status to N/A. However, when you check the test set and the Steps - they same to be No Run status. Is it incorrect to expect that even the steps will reflect as N/A? Or - Is it logically correct that since the Test case was not executed from the wizard that the steps remain in No Run. Tue, 24 Aug 2021 19:00:04 -04002021-08-25T01:50:45-04:00/Support/Forum/spiraplan/issues-questions/2475.aspxmessageId=4097David J (support1@inflectra.com) Yes that is correct and expected behavior. Yes that is correct and expected behavior. Wed, 25 Aug 2021 01:50:45 -04002021-08-25T01:50:45-04:00/Support/Forum/spiraplan/issues-questions/2475.aspx#reply4097