Inflectra Customer Forums: Requirement status change blanks out Release selection. (Thread)Hi Adam, When a colleague changes a Requirement Status from Planned to Accepted, the Release section is blanked out. When she changes the requirement back to Planned, the Release selection is visible again. I have replicated this myself. SpiraTeam 4.1.0.6 Thanks, Ruth en-US(C) Copyright 2006-2026 Inflectra Corporation.support@inflectra.com/Computers/Software/Project_Management//Computers/Software/Quality_Assurance/KronoDesksupport@inflectra.comhttp://www.inflectra.com/kronodesk/forums/threads120/Support/Forum/spirateam/issues-questions/1229.aspxthreadId=1229Ruth L Collier (ruthlavinia@me.com)workflowRequirement status change blanks out Release selection. Hi Adam, When a colleague changes a Requirement Status from Planned to Accepted, the Release section is blanked out. When she changes the requirement back to Planned, the Release selection is visible again. I have replicated this myself. SpiraTeam 4.1.0.6 Thanks, Ruth Thu, 11 Jun 2015 15:31:12 -04002015-06-14T00:39:13-04:00/Support/Forum/spirateam/issues-questions/1229.aspxmessageId=2144Jim R (donotreply5@kronodesk.net) Hi Ruth Depending on how you have the workflow configured this may be correct behavior. I would Hi Ruth Depending on how you have the workflow configured this may be correct behavior. I would log a help desk ticket with some descriptions of how your requirements workflow is configured so that we can better assist you. Regards Jim Sun, 14 Jun 2015 00:39:13 -04002015-06-14T00:39:13-04:00/Support/Forum/spirateam/issues-questions/1229.aspx#reply2144