In my Test Set the Execution Status is not run, if I open one of the test cases in the Set it shows an execution status. I noticed there is a Read Only Field in my test set Display For. It is under the Releases Tab along with the Scheduled drop-down Display For is set to an earlier release. Im thinking if that field points to the correct Release my test Set will correctly display testcase execution status en-US(C) Copyright 2006-2026 Inflectra Corporation.support@inflectra.com/Computers/Software/Project_Management//Computers/Software/Quality_Assurance/KronoDesksupport@inflectra.comhttp://www.inflectra.com/kronodesk/forums/threads120/Support/Forum/spirateam/issues-questions/2453.aspxthreadId=2453Greg Hanson (ghanson@multitech.com) In my Test Set the Execution Status is not run, if I open one of the test cases in the Set it shows an execution status. I noticed there is a Read Only Field in my test set Display For. It is under the Releases Tab along with the Scheduled drop-down Display For is set to an earlier release. Im thinking if that field points to the correct Release my test Set will correctly display testcase execution status Tue, 20 Jul 2021 15:06:01 -04002021-07-20T15:44:05-04:00/Support/Forum/spirateam/issues-questions/2453.aspxmessageId=4041Greg Hanson (ghanson@multitech.com) I figured out the problem I had a Release selected on Test Sets Page. Tue, 20 Jul 2021 15:44:05 -04002021-07-20T15:44:05-04:00/Support/Forum/spirateam/issues-questions/2453.aspx#reply4041