Hello, When running a test case currently, if there is a step that fails, the incident only pulls the information from that test case meaning any additional information that has been written about methodology etc in the other steps could potentially be missed, is there any way to raise an incident with the information of all the steps in the test case in it? Many Thanks, Ben en-US(C) Copyright 2006-2026 Inflectra Corporation.support@inflectra.com/Computers/Software/Project_Management//Computers/Software/Quality_Assurance/KronoDesksupport@inflectra.comhttp://www.inflectra.com/kronodesk/forums/threads120/Support/Forum/spiratest/issues-questions/1162.aspxthreadId=1162Ben Patterson (benjamin.patterson@theconsortium.com)reporting Hello, When running a test case currently, if there is a step that fails, the incident only pulls the information from that test case meaning any additional information that has been written about methodology etc in the other steps could potentially be missed, is there any way to raise an incident with the information of all the steps in the test case in it? Many Thanks, Ben Thu, 12 Feb 2015 16:50:16 -05002015-02-13T16:41:37-05:00/Support/Forum/spiratest/issues-questions/1162.aspxmessageId=2053Inflectra Sarah (donotreply6@kronodesk.net) Hi Ben It should pull the list of steps (and their descriptions) from the test case as well as the full details of the current step. It also adds a link to the test run in the Associations tab of the incident. Adding all of the fields from all of the steps would probably add too much clutter. Regards Sarah. Fri, 13 Feb 2015 16:41:37 -05002015-02-13T16:41:37-05:00/Support/Forum/spiratest/issues-questions/1162.aspx#reply2053