I've got a short test case of 6 steps. I completed the first 4 steps, then clicked on PAUSE. Going to 'My Page' I see the pending test run. I click on Resume, and the Test Execution Wizard page opens, asking for the Release To Execute Against. The 6 steps are shown in the left side window with the 4 completed tests marked in green and with a check mark. Clicking on any of the steps results in the "Loading..." message to appear, but after a few seconds it goes away, and nothing happens on the screen. I'm still at the Test Execution Wizard page, asking for the Release To Execute Against. Seems to me I should be able to click on any step and be taken there. Please advise. en-US(C) Copyright 2006-2026 Inflectra Corporation.support@inflectra.com/Computers/Software/Project_Management//Computers/Software/Quality_Assurance/KronoDesksupport@inflectra.comhttp://www.inflectra.com/kronodesk/forums/threads120/Support/Forum/spiratest/issues-questions/404.aspxthreadId=404Jeff Szlauko (jszlauko@xendata.com) I've got a short test case of 6 steps. I completed the first 4 steps, then clicked on PAUSE. Going to 'My Page' I see the pending test run. I click on Resume, and the Test Execution Wizard page opens, asking for the Release To Execute Against. The 6 steps are shown in the left side window with the 4 completed tests marked in green and with a check mark. Clicking on any of the steps results in the "Loading..." message to appear, but after a few seconds it goes away, and nothing happens on the screen. I'm still at the Test Execution Wizard page, asking for the Release To Execute Against. Seems to me I should be able to click on any step and be taken there. Please advise. Wed, 24 Oct 2012 18:24:08 -04002012-10-24T20:39:50-04:00/Support/Forum/spiratest/issues-questions/404.aspxmessageId=772David J (adam.sandman+support@inflectra.com) Hi Jeff Just click the "Next" button on the Release selection page and then you can navigate the tree. Regards Adam Wed, 24 Oct 2012 20:20:30 -04002012-10-24T20:20:30-04:00/Support/Forum/spiratest/issues-questions/404.aspx#reply772messageId=773Jeff Szlauko (jszlauko@xendata.com) Thank you, that did it. However, I noticed that if I enter some text into the 'Actual Result' box, then click Pause, then resume and return to that step, the 'Actual Result' is now blank. I believe I saw a post somewhere else concerning this. Maybe this is by design. Not a big issue if it is. Wed, 24 Oct 2012 20:39:50 -04002012-10-24T20:39:50-04:00/Support/Forum/spiratest/issues-questions/404.aspx#reply773