Why is it not possible to assign a requirement to a test step in the excel importer (or spiratest), in my experience I should be able to have many test requirements / conditions within in a test case and should be able to pass or fail varying test requirements / conditions however it only seems to associate the requirement with the full test case en-US(C) Copyright 2006-2026 Inflectra Corporation.support@inflectra.com/Computers/Software/Project_Management//Computers/Software/Quality_Assurance/KronoDesksupport@inflectra.comhttp://www.inflectra.com/kronodesk/forums/threads120/Support/Forum/spiratest/issues-questions/417.aspxthreadId=417Grant Bell (grant.bell@geckots.co.uk) Why is it not possible to assign a requirement to a test step in the excel importer (or spiratest), in my experience I should be able to have many test requirements / conditions within in a test case and should be able to pass or fail varying test requirements / conditions however it only seems to associate the requirement with the full test case Mon, 05 Nov 2012 11:40:42 -05002012-11-05T11:42:47-05:00/Support/Forum/spiratest/issues-questions/417.aspxmessageId=786Grant Bell (grant.bell@geckots.co.uk) Please note this is also similar to test incidents which are not associated with a test step but instead a test case and therefore effects all requirements. Could this be a config setup change? Mon, 05 Nov 2012 11:42:47 -05002012-11-05T11:42:47-05:00/Support/Forum/spiratest/issues-questions/417.aspx#reply786