A test set was completed and Finished was clicked, but the test set will now show as Deferred instead of Completed. There were no test cases/steps that was not passed or failed. Is there a way to make it say completed instead of deferred and NOT have to run through the whole test set again.en-US(C) Copyright 2006-2026 Inflectra Corporation.support@inflectra.com/Computers/Software/Project_Management//Computers/Software/Quality_Assurance/KronoDesksupport@inflectra.comhttp://www.inflectra.com/kronodesk/forums/threads120/Support/Forum/spiratest/issues-questions/433.aspxthreadId=433lana krohne (lana.krohne@geha.com)A test set was completed and Finished was clicked, but the test set will now show as Deferred instead of Completed. There were no test cases/steps that was not passed or failed. Is there a way to make it say completed instead of deferred and NOT have to run through the whole test set again.Wed, 21 Nov 2012 15:23:47 -05002012-11-23T11:25:58-05:00/Support/Forum/spiratest/issues-questions/433.aspxmessageId=821David J (adam.sandman+support@inflectra.com) Hi Iana You can just go to Testing > Test Sets and click on the EDIT button next to the test set in question. Then you can switch the status to Completed. Regards Adam Fri, 23 Nov 2012 11:25:58 -05002012-11-23T11:25:58-05:00/Support/Forum/spiratest/issues-questions/433.aspx#reply821