I created my test cases. I then created my test set. I then execute the test cases that are in the test set, I then review the results in the Test Run. OOPS, i just realized that one of the test cases was accidentally set to FAILED when it should have been PASSED. Is there a way to edit the 'Execution Status' after I have completed the execution of a Test Set? What can i do to repair my mistake? en-US(C) Copyright 2006-2026 Inflectra Corporation.support@inflectra.com/Computers/Software/Project_Management//Computers/Software/Quality_Assurance/KronoDesksupport@inflectra.comhttp://www.inflectra.com/kronodesk/forums/threads120/Support/Forum/spiratest/issues-questions/508.aspxthreadId=508Tom Emich (thomas.emich@inin.com) I created my test cases. I then created my test set. I then execute the test cases that are in the test set, I then review the results in the Test Run. OOPS, i just realized that one of the test cases was accidentally set to FAILED when it should have been PASSED. Is there a way to edit the 'Execution Status' after I have completed the execution of a Test Set? What can i do to repair my mistake? Fri, 15 Feb 2013 17:13:39 -05002013-02-20T17:38:23-05:00/Support/Forum/spiratest/issues-questions/508.aspxmessageId=943David J (adam.sandman+support@inflectra.com) You just need to go to Testing > Test Sets, click on the specific test set. Then in the "Test Cases" section of the test set, check the box for the test case that you need to change and click 'Execute Test Cases", that will allow you to just execute the one test case in the set and use the PASS ALL button to mark it as passed.Wed, 20 Feb 2013 17:38:23 -05002013-02-20T17:38:23-05:00/Support/Forum/spiratest/issues-questions/508.aspx#reply943