Hi All, I have one release example (rel 1.0.0.0) and one test case example(TC 1). First I mapped test case (TC 1) to release ( rel 1.0.0.0 ) and then change the test case Active status as [ NO ]. But when I go back on the test case main screen test case execution status display as [ Not Run ]. It should be display as [ N/A ]. When I try to set Active status as [ NO ] to the test case without mapped any release and check on the test case main screen test case execution status display as [ N/A ]. I want to set some of the test case execution status as [ N/A ] which is mapped to any Release. Could anyone help me to short out this problem ASAP. Thanks in Advance!! en-US(C) Copyright 2006-2026 Inflectra Corporation.support@inflectra.com/Computers/Software/Project_Management//Computers/Software/Quality_Assurance/KronoDesksupport@inflectra.comhttp://www.inflectra.com/kronodesk/forums/threads120/Support/Forum/spiratest/issues-questions/693.aspxthreadId=693Akhilesh Verma (akhilesh.verma@e-navik.com) Hi All, I have one release example (rel 1.0.0.0) and one test case example(TC 1). First I mapped test case (TC 1) to release ( rel 1.0.0.0 ) and then change the test case Active status as [ NO ]. But when I go back on the test case main screen test case execution status display as [ Not Run ]. It should be display as [ N/A ]. When I try to set Active status as [ NO ] to the test case without mapped any release and check on the test case main screen test case execution status display as [ N/A ]. I want to set some of the test case execution status as [ N/A ] which is mapped to any Release. Could anyone help me to short out this problem ASAP. Thanks in Advance!! Sun, 25 Aug 2013 00:09:29 -04002013-08-30T14:27:28-04:00/Support/Forum/spiratest/issues-questions/693.aspxmessageId=1253David J (adam.sandman+support@inflectra.com) Hi Akhilesh This is actually working as designed. The Active=No option only affects the test cases when displayed with Releases = All, since it's meant to denote which test cases are in use for future testing (i.e. should be added to new releases). For existing releases, the status will still be displayed as a historical result. If you don't want the result to show up, you should simply un-map the test case from the release. Regards Adam Mon, 26 Aug 2013 03:22:19 -04002013-08-26T03:22:19-04:00/Support/Forum/spiratest/issues-questions/693.aspx#reply1253messageId=1269Akhilesh Verma (akhilesh.verma@e-navik.com) Many Thanks Adam!! Fri, 30 Aug 2013 14:27:28 -04002013-08-30T14:27:28-04:00/Support/Forum/spiratest/issues-questions/693.aspx#reply1269